Lynx-studio Hilo Version 5 Firmware Manual do Utilizador descarregar pdf (Página 3)

1.2.1 Sync Source

When the LT-USB is NOT connected to the computer,

the Sync Source may be changed to one of the following

four choices:

• Internal: Clock driven by the Hilo’s crystal oscillator

• Word Clock: Clock derived from the WORD

CLOCK input

• Digital: Clock derived from the active digital input

• ADAT In: Clock derived from the ADAT input.

Once an ADAT signal is detected on the Optical

Input, Hilo automatically switches the Optical input

from S/PDIF to ADAT. In this mode, the additional

ADAT inputs will appear as available channels on

the output mix routing page; meter source selection

and the test tone page.

Please note that Word Clock/2 and Word Clock/4 are not

available in version 5 firmware.

1.2.2 Output Mix Routing Page

1.2.2.1 Solo Button

The new Solo button allows any active input channel to

be isolated. This allows very rapid comparison of sources,

A/B switching, and a convenient way for troubleshooting

audio anomalies.

Simply press the Solo button and it will engage and turn

green with the word “Solo” blinking.

In this state, press any input source button and you will

hear that audio exclusively. Pressing any other input

source will instantly switch to the alternate source.

When done, tapping the Solo button returns Hilo to the

previous state, where multiple input sources can stream to

an output simultaneously.

1 2 3 4 5 6 7 8 ... 12 13

Sem comentários

Lynx-studio Hilo Version 5 Firmware Manual do Utilizador Página 3